Marine

NEW
Check out our New Marine Application

This motor includes the adapter plate and the splined female armature shaft matches the male shaft of the drive unit, it simply bolts right in where the engine was – I would estimate 1-hour to remove engine, and 15 minutes to bolt motor in.

The spline data is:
11 teeth, pitch 16/32 30 degree with an ID of .6300 Merc/Mariner magnum drive units. Though we put ours on a 40HP, They are the same up to around 90 HP. < COST: (Motor, Adapter Plate and Bolts ONLY. Controller and Batteries extra). $2,250.00 for the 40HP version. >$2,500.00 for the 50HP version.
$2,750.00 for the 60HP version.
$3,000.00 for the 70PH version.
PLUS LABOR

Note the adapter plate, and the HOOD of the engine fits nicely over all of this with 2″ to spare…

DROP YOUR MERC/MARINER OFF AT THE GREEN SHED FOR INSTALLATON
or
STAY and get in installed under our ASSISTED* PROGRAM (*Assisted Rates Apply).

EP-5
AC OUTBOARD MOTOR

Horsepower rating 5 h.p.
Kilowatts rating (continuous output) 3.7 kW
Voltage 48 vdc
Maximum current 100 amps DC
Motor Brushless PMAC
Comparable gas outboard (propulsive power) 6 h.p.
Comparable gas outboard (thrust) 7 h.p.
Static thrust 130 pounds
Cooling system Water cooled
Control system Remote control
Remote control Side mount, 7 pin cable
Optional remote cable Yes, 6 foot lengths
Weight 65 pounds
Size (height, width, length) 46 x 11 x 19 inches
Transom Height 20 inches
Lower unit gear ratio 2.08:1 (27/13)
Gear oil capacity 8.5 ounces
Trim and/or tilt Manual
Propeller 3-7 x 7

$2,999.00
Batteries and Controller sold Separately.
*Batteries $1.35 per ah. ( Plus shipping, customs, duties).
*Controller: prices vary depending on Controller chosen. See our EV PARTS tab

*********************************************************************************************************************

CALL FOR PRICING and OPTIONS: Electric System and Hybrid Electric Available.

EP-600: up to 25′, 6hp, 4 – 5.5knots,36V, Charger
EP-1200 20′ to 35′,12hp, 5 – 6.5knots,48V, Charger
EP-2000 25′ to 40′, 20hp,5.5 – 7knots, 72V, Charger
EP-4000 32′ to 40′,25 – 45hp, 6 -8knots, 108V, Charger
EP-7000 38′ to 56′, 70hp, 7-8.5knots 108V, Charger
EP-10000 50’to 85′, 100hp,7 – 9knots, 144V, Charger

KIT INCLUDES:
Elco Motor
Battery Charger
E-Gauge
Throttle
Ignition Key and Switch
Power on Light
Power Boost Button
Controller/Inverter
15′ Pre-wired harness

Electric Motor Benefits:
Plug & Play system Components
Water & Particle resistant to IP65 Standards
No heat, noise or vibration
No water Cooling necessary
Brushless AC System
One Moving Part
Not Thru-hulls
Lower Operating costs than diesel

Available OPTIONS:
AGM or Lithium Batteries
Quick Chargers
Motor Mounts
Solar Panels
Sail Drive Units
Propellers
Couplers
Wind Turbines

* * * * * * * * * * *

#Greenshedconversions.com

 

 

GreenShedConversions